Anthony Magnum Railtrac Heavy Duty Series Liftgates

LED Tail Lights

Standard LED lights in rear column are pre-wired and pigtailed for easy servicing.

2-Part Power Unit Enclosure

Dual pump and motor in one enclosure;dedicated batteries housed separately. Both units are powder coated galvaneal steel with removable covers for full access

Marine-Duty Potted Toggle Switch

Operates reliably under all types of weather conditions

Pressure Compensated Flow Valve

Provides constant and controlled lowering speed of the platform, loaded or unloaded

Closed Hydraulic System

Provides positive protection against outside dust, dirt, and moisture; protects against hydraulic contamination

Yellow Di-Chromate Plated Pivot Pins

Resist corrosion to increase service life

Heat-Shrink Siliconed Wire Connections

Prevent electrical failure by sealing out moisture at all electrical connections and stainless steel fasteners on all electrical terminals provide extra corrosion protection

Hard Chrome Plated Piston Rod

Helps keep exposed surface free of rust and contamination to protect seals and extend cylinder life

Relief Valve

Prevents overloading during lifting cycle

Factory Installed Hydraulic Fluid

Our Optimum cold weather ussage specified fluid is factory installed thus preventing contamination from field installations, while providing good performance during cold weather operations

Super Cylinders

Built to last with longer piston and rod glands, dual wear rings, double-lip piston and rod seals...translate into less downtime, lower maintenance, and more trouble-free operation

Powered Platform

Toggle-switch controlled hydraulic system provides easy opening and powered closing.

Shot Blast/Powder Coat

All platforms and weldments are prepped with steel shot and then powder coated for a finish that provides the best surface appearance, impact resistance, coating adhesion, and wear resitance. Our finish has passed a 1,000 hour salt spray test

Circuit Protection Device

A 200 Amp service protects truck wiring and power system in the event of a "dead short"

Shipped Ready to Mount

Each Anthony liftgate is factory assembled, energized, tested, pressure set, and oil filled to ensure the hightest quality

E-Z Mount Installation

Shipped completelly pre-assembled for fast,clean, easy installation

Cut-Off Switch

Protects valuable liftgate equipment from unauthorized use or vandalism